Holiday Gift Card Holder

Holidaygiftcard

Create this quick and festive gift card holder to jazz up your holiday gift giving to friends and family!

Img_2173

Cut your base for the gift card using your Pop N Cuts Base. If you cut your cardstock 4 1/4" by 11" it will just fit over the die. Make sure you position it correctly before cutting it out.

Img_2174

Using your Simply Scored Board, position your card base with the flat side to the left edge of the board and score your piece at 3 1/2", 5 1/2", and 7 1/2".

Img_2176

Fold your base using the valley/mountain fold by folding the first score line down, the second up, and the last score line down again.

Img_2177

Using your Sticky Strip, tape the holder together on the bottom inside. Make sure that when you put your sticky strip on you place it as close to what will be the bottom of your gift card holder. If you place the sticky strip too high you will not be able to slide your gift card in later.

Img_2178

Use your Word Window punch to create the opening for your gift card. Insert your cardstock half way into your word window punch and punch. Make sure to leave a space on either side. It helps to use your punch upside down so you can line it up as you go.

Holidaygiftcard

Decorate the front of your gift card holder. I used a 4 1/4" by 2" piece of Designer Series Card Stock from the Winter Frost Paper Pack, Pool Party Seam Binding Ribbon. Add the stamped A Gift For You greeting in Smokey Slate.

Img_2096

Finally add your gift card!

122924s Pool Party 8-1/2" X 11" Cardstock 122924

100730s Whisper White 8-1/2" X 11" Cardstock 100730

132183s Winter Frost Designer Series Paper Stack 132183

134765s A Gift For You Clear-Mount Stamp Set 134765

131179s Smoky Slate Classic Stampin' Pad 131179

124005s Silver Glimmer Paper 124005

130099s Card Base Pop' N Cuts 130099

113478s Extended Cutting Big Shot Accessory Pads 113478

113439s Big Shot 113439

104294s Sticky Strip 104294

119857s Window Word Punch 119857

132153s Label Bracket Punch 132153